DC/AC Power Inverters from 5KVA..500KVA

For Your Application

PCTI can provide the DC/AC inverters you need for your specific application. PCTI inverters are digital signal processor (DSP) controlled based on IGBT PWM technology. This superior next-generation control allows us to provide a single control board solution for the inverter, thus increasing reliability by reducing control components. Whether you need a high quality AC waveform suitable for sensitive electronic equipment or some other purpose, contact PCTI about power inverters for more details. If you need help in specifying your inverter, contact PCTI or request a quote.

Custom Products Designed for You

Our power inverters are built to customer order based on our standard designs and offer high performance, high reliability and sophisticated control systems. Applications include remote power stations, grid tie in systems (including dc power supplies for grid tie systems), microgrids, renewables including wind, solar, fuel cells, transportation, backup power, overhead cranes, as well as many others. A variety of computer interfaces are available to meet all of your inverter programming and control requirements.

Following are our standard specifications.

Contact us for options not listed here or for assistance regarding your particular application.

Power range:
• 5KVA to 2.5MVA (2.5MVW)
Input service:
• Any input from 24V to 800VDC
Output service:
• Any standard voltage, may be 1 or 3 phase
Voltage regulation:
• 0.1% for any line and load combination
AC output frequency:
• Any frequency up to 20kHz
Frequency regulation:
• ±0.05%
Sine wave generation:
• PWM (pure sine) or Square Wave
Control technology:
• Digitally synthesized Pulse Width Modulation
THD-linear loads:
• 3%
THD-nonlinear loads:
• 4%
• 90% or better

NEMA enclosure types:
• 1, 3R, 12, 4, 4X
Operating temperature:
• -5°C to 40°C
Storage temperature:
• -10°C to 65°C
• Up to 90% non-condensing


• Overcurrent
• Overvoltage
• Undervoltage
• Input Reverse Polarity
• Overtemperature
• Electronic
• Current limiting
• Input to output transformer isolation
• Input MOVs
• Output MOVs

Analog Signals:
• 4-20mA, 0-5V, 0-10V
Computer Interface:
•  Ethernet, profibus, Modbus, CANbus, IEEE 488.2/GPIB, RS232, RS485
• Start/Stop, Reset, Fault, Inhibit, Current Adjust, Voltage Adjust, Fault Indication (UV, OV, OC, other)

• Input circuit breaker
• Power ON Indicator
• Run indicator
• Undervoltage indicator
• Overvoltage indicator
• Voltage trim adjust + 10%
• Start pushbutton
• Stop/Reset pushbutton
• Fault indicator
• Analog Output Voltmeter w/3 Phase selector switch
• Analog Output Ammeter w/3 Phase selector switch

• Forced air
• Direct Water
• Closed Loop Water to Water Heat Exchanger
• Heatpipe
• Natural Convection
Water System Protection:
• Low flow, temperature, resistivity, leak detection, low level